#
# Example Configuration File for AM-VS Module
# Camera: JAI M1 variable scan mode , non interlaced, PCVision board
#
# Matthias Stein 09/98
#


[PCVision:0]		# Board 0

[AM-V:0]		# Module AM-PV No. 0

[CameraPort:0]		# Camera 0

     Camera_Name = "JAI M-1 fps:12 (8bit)"

# attention! opposed to ITI we use the real (not the register) values */

     HTotal = 780		# use value + 1 * 2
     HSync_Low = 58		# use value + 1
     HEqual_End = 28		# use value + 1
     Serration_Total = 332	# use value + 1
     VTotal = 1050		# use value + 1 (half lines)
     VSync_Low = 6		# use value + 1 (half lines)
     HSync_Pol_Lo
     VSync_Pol_Lo
     VGate_Start = 519		# use value + 1 (half lines)
     VGate_End = 12		# use value + 1 (half lines)
# width = (HActive - HOffset) % 4 == 0 !
     HOffset = 329		# use value + 1
     HActive = 1607		# use value + 1
# height = VActive - VOffset
     VOffset = 8		# use value + 1 
     VActive = 1024		# use value + 1
     Strobe_Delay = 1		# use value + 1
     LEN_Polarity_Lo
     FEN_Polarity_Lo
     FRST_Offset_Delay = 1	# use value + 1
     FRST_Disable
     FRST_Active_Hi
     FRST_FROFF_Period
     FRST_Vsync_Disable
     PTG_HSYNC_Select
     CHSYNCEN_Enable
     VSYNCEN_Enable
     XTAL_Mode
     LPF_Enable
     VSCAN_Enable
     Scale_1.5
     VClk_Inverted
     NonInterlaced
     FLDSHFT_Enable
     Trig_Disable
     Ext_Trigger
     Trigger_Active_Lo
     Strobe_Fast
     Strobe_Disable
     Strobe_Active_Hi
     Skip_Field_Disable
     Clamp_Delay = 14
     Clamp_Src_Sync_Strip
     Clamp_On_LEN_Rise
     PRef = 192
     NRef = 0
     PLL_FDIV = 780		# use value + 1
# the adjustment of some pllregs is not supported (it doesn't make sense)
#    PLL_LO = 0
#    PLL_HI = 0
     PLL_RDIV = 910		# use value + 1
#    PLL_REFPOL_Hi
     PLL_VCO = 5
#    PLL_PFD = 3
#    PLL_PDEN_Hi
#    PLL_INTFLT_Lo
#    PLL_INTVCO_Hi
#    PLL_CLKSEL_Hi
#    PLL_Internal_Feedback
#    PLL_FBKPOL_Hi
#    PLL_ADD_Lo
#    PLL_SWLW_Lo
     PLL_PDA = 2
#    PLL_PDB = 3
#    PLL_LDLG_Hi
#    PLL_FINEEN_Lo
     PLL_LCOUNT = 5
#    PLL_OMUX1_Lo
#    PLL_Ext_Ref_Mode