#
# Example Configuration File for PCDig Module
# Camera: SMD 1M60/ Dalstar 1M60
#
# Peter Falus 06/00
#


[PCD:0]			# Board 0

      CAMERA_NAME = "SMD 1M60 fps:60"

      EXO_FILENAME = "p4b2tn00.exo"
      LEN_SYNC = SYNC
      LEN_POLARITY = RISING_EDGE
      FEN_ENABLE = ENABLE
      FEN_POLARITY = RISING_EDGE
      MULTI_ENABLE = DISABLE
      MULTI_POLARITY = ACTIVE_LOW
      MULTI_INPUT_MODE = MULTI_INPUT_FIELD
#     PCLK_POLARITY = FALLING_EDGE		# read only register
#     MULTI_OUTPUT_ENABLE = DISABLE		# this is not configurable
#     USE_EXT_MULTI = DISABLE			# this is not configurable
      RETIME_ENABLE = DISABLE
      RETIME_POLARITY = FALLING_EDGE
      CAM3_ENABLE = DISABLE
      EXSYNC_ENABLE = ENABLE
      EXSYNC_POLARITY = ACTIVE_HIGH
      EXSYNC_MODE = EXSYNC_SOFT_TRIG
      PRI_ENABLE = DISABLE
      PRI_POLARITY = ACTIVE_LOW
      CAM_MODE_CTL = 0
      CCLK_STATIC_ENABLE = ENABLE
      CCLK_STATIC_STATE = LEVEL_LOW
#     EXT_SYNC_TIME = 572.000			# us (140ns ... 572us)
      # default exposure time !!!
      EXT_SYNC_PERIOD_TIME = 140000.000		# us (210ns ... 18.75s)
      # default readout time !!!
      EXSYNC_MIDPOINT_DELAY = 210000.000	# us (210ns ... 18.75s)
      # this controls the same as the above value (readout time)
      # the last value is the important (overwrites the first)
      PRI_MIDPOINT_DELAY = 210000.000		# us (210ns ... 18.75s)
      EXSYNC_START_LOCATION = EXSYNC_START_CYCLE_END
      PRI_START_LOCATION = PRI_START_CYCLE_END
      PRI_END_LOCATION = PRI_END_IS_START_DEPEND
      HORZ_OFF = 14 
      WIDTH_PIXELS = 256  # 4x256 without binning,  
				  # 2 taps per framegrabber 
      VERT_OFF = 10 
      HEIGHT_PIXELS = 1024 # 1024 without binning
      CCLK_FREQ_SEL = 14.318000			# MHz (320kHz ... 100MHz)
      PIXEL_SIZE = 12
      TRIGGER_POLARITY = FALLING_EDGE,FALLING_EDGE
      TRIGGER_SRC = TTL_TRIG,TTL_TRIG
      TRIG_GLITCH_DETECTOR = DISABLE,DISABLE
#     TRIGGER_STATE = LEVEL_HIGH,LEVEL_LOW	# read only register
#     GEN_SW_TRIGGER = 2118125364,2118125364	# this is not configurable
      TRIG_DIVIDE_FACTOR = 0
      TRIG_DIVIDE_CONTROL = DISABLE_TRIG_DIVIDE
#     PARAM_GROUPS_APPLICABLE = 14
      IMAGE_GEOMETRY = 2CHAN_SEP_TAP_L2R
#     NUM_CAMERAS = 1