#
# Example Configuration File for PCDig Module
# Camera: Vosskuehler HCC-1000 (8bit, full resolution)
#
# Matthias Stein 09/01
#


[PCD:0]			# Board 0

      CAMERA_NAME = "Vosskuehler HCC-1000 fps:462" # 923,1825,6100fps
      EXO_FILENAME = "p2b1tn00.exo"
      LEN_SYNC = ASYNC
      LEN_POLARITY = RISING_EDGE
      FEN_ENABLE = ENABLE
      FEN_POLARITY = RISING_EDGE
      MULTI_ENABLE = DISABLE
      MULTI_POLARITY = ACTIVE_HIGH
      MULTI_INPUT_MODE = MULTI_INPUT_FIELD
#     PCLK_POLARITY = FALLING_EDGE		# read only register
#     MULTI_OUTPUT_ENABLE = DISABLE		# this is not configurable
#     USE_EXT_MULTI = DISABLE			# this is not configurable
      RETIME_ENABLE = DISABLE
      RETIME_POLARITY = RISING_EDGE
      CAM3_ENABLE = DISABLE
      EXSYNC_ENABLE = DISABLE			# all control via rs232
      EXSYNC_POLARITY = ACTIVE_HIGH
      EXSYNC_MODE = EXSYNC_SOFT_TRIG
      PRI_ENABLE = DISABLE
      PRI_POLARITY = ACTIVE_HIGH
      CAM_MODE_CTL = 0				# all control via rs232
      CCLK_STATIC_ENABLE = ENABLE
      CCLK_STATIC_STATE = LEVEL_HIGH
#     EXT_SYNC_TIME = 572.000			# us (140ns ... 572us)
      # default exposure time !!!
      EXT_SYNC_PERIOD_TIME = 40000.000		# us (210ns ... 18.75s)
      # default readout time !!!
      EXSYNC_MIDPOINT_DELAY = 80000.000		# us (210ns ... 18.75s)
      # this controls the same as the above value (readout time)
      # the last value is the important (overwrites the first)
      PRI_MIDPOINT_DELAY = 80000.000		# us (210ns ... 18.75s)
      EXSYNC_START_LOCATION = EXSYNC_START_CYCLE_END
      PRI_START_LOCATION = PRI_START_CYCLE_END
      PRI_END_LOCATION = PRI_END_IS_START_DEPEND
      HORZ_OFF = 0
      WIDTH_PIXELS = 1024			# 256 with HCC-1000F
      VERT_OFF = 0
      HEIGHT_PIXELS = 1024			# 512/256 also possible
      CCLK_FREQ_SEL = 15.000000			# MHz (320kHz ... 100MHz)
      PIXEL_SIZE = 8
      TRIGGER_POLARITY = FALLING_EDGE,FALLING_EDGE
      TRIGGER_SRC = TTL_TRIG,TTL_TRIG
      TRIG_GLITCH_DETECTOR = DISABLE,DISABLE
#     TRIGGER_STATE = LEVEL_HIGH,LEVEL_LOW	# read only register
#     GEN_SW_TRIGGER = 2118125364,2118125364	# this is not configurable
      TRIG_DIVIDE_FACTOR = 256
      TRIG_DIVIDE_CONTROL = DISABLE_TRIG_DIVIDE
#     PARAM_GROUPS_APPLICABLE = 14
#     IMAGE_GEOMETRY = 1CHAN_L2R
#     NUM_CAMERAS = 1